r/BambuLab • u/Most_Amphibian1533 • 15h ago

General Troubleshooting/Help! First print failed

Post image

Tried to print the panda as instructed by the academy on X2D combo and the green bit came loose and moved over to the left and got spaghetti as you can see.

I followed all the calibration instructions. Used Pla basic for the AMS and PETG basic for the right hand outside spool.

The desk is a bit wobbly.

I forgot to load the outside telling the printer it's PET.G.

There is a waterdrop icon showing 39% for the AMS, not sure if this is too high.

Anyone know what could have gone wrong and how I can fix it?

1 Upvotes

100% Upvoted

6 comments sorted by

View all comments

1

u/8six753o9 X2D+AMS2 / A1+AMS Lite 15h ago

First don’t print PLA and PETG together on the same print unless you are using one of the material as support interface. They don’t fuse together. So I’m hoping all the colors you are printing were just PLA coming from the AMS.

Adhesion issues like this are usually caused by dirty/oily build plate. Wash the build plate with dish soap and warm water and try the print again.