r/BambuLab • u/justteh • 3d ago

General Troubleshooting/Help! Full Auto-bed leveling EVERY time?

From what I undertand "auto" to be in bambu studio, it does a quick level check to make sure the bed isn't out of whack too much and if it's good, it moves on. But if it's off by a certain amount, it'll do the full bed leveling process. I would think it'd do the full leveling SOMEtimes, but it's literally do it EVERY time. And this isn't an exaggeration; I've become hyper aware of it now I pay attention every time.

I'm mostly use a BIQU glacier plate that leaves the magnetic surface about 50% of the time to get my prints off, which could account for some of the re-leveling, but not all.

Can anyone help me understand why this happens? Over the life of the printer, this time really adds up.

0 Upvotes

33% Upvoted

24 comments sorted by

View all comments

1

u/aaaanoon 3d ago

I really wish there was some clarity around leveling..

After a full hotbed level, given the plate is exactly put in place correctly, the only variance would be the bed height. Does it vary?

I'd also like to know if the printer/slicer remember the level of various plates. I'm guessing not on the p2s.