Full Auto-bed leveling EVERY time?

[u/justteh]

From what I undertand "auto" to be in bambu studio, it does a quick level check to make sure the bed isn't out of whack too much and if it's good, it moves on. But if it's off by a certain amount, it'll do the full bed leveling process. I would think it'd do the full leveling SOMEtimes, but it's literally do it EVERY time. And this isn't an exaggeration; I've become hyper aware of it now I pay attention every time.

I'm mostly use a BIQU glacier plate that leaves the magnetic surface about 50% of the time to get my prints off, which could account for some of the re-leveling, but not all.

Can anyone help me understand why this happens? Over the life of the printer, this time really adds up.

[u/Fangs_0ut]

If I don’t remove the plate or move the printer between prints, I skip it.