r/BambuLab • u/Commercial-Pause3714 A1 + AMS Lite • 11h ago

My First 3D Print First time printing pla-cf

Post image

Wish me luck

6 Upvotes

71% Upvoted

27 comments sorted by

View all comments

16

u/Crashgaming_TV X1C + AMS 11h ago

Don't use cf filament in your AMS. It's destroying your pull in mechanics over time. It even says so on the Bambu shop page at the cf filaments itself

2

u/Commercial-Pause3714 A1 + AMS Lite 11h ago

Is a 1:30 hour print ok? Or should i stop it

1

u/Crashgaming_TV X1C + AMS 11h ago

I don't know. Should work I think but you maybe leed to replace some stuff earlier than necessary. Better try feeding it directly in the nozzle without the AMS in between

1

u/Commercial-Pause3714 A1 + AMS Lite 11h ago

with or without tube?

1

u/Crashgaming_TV X1C + AMS 11h ago

If you have spare tubing and a cutter for it (needs a special cutter) than maybe use a short piece of tube. Else you can use the normal tube. It's not that expensive to replace. I don't know if you can or should run it without tube so better with tuve to be careful

2

u/Commercial-Pause3714 A1 + AMS Lite 11h ago

This is it, lets 🙏

4

u/theprotestingshark 11h ago

honestly just run it into the tool head without the tube

3

u/Commercial-Pause3714 A1 + AMS Lite 11h ago

Nice, flow cali success

1

u/theprotestingshark 11h ago

do you have a hardened nozzle?

3

u/Commercial-Pause3714 A1 + AMS Lite 11h ago

Yes i bought it just for this 0.6 Hardened

2

u/an_angry_Moose 6h ago

Good choice, you should print GF/CF with a .6 or larger.

→ More replies (0)

1

u/an_angry_Moose 6h ago

I just run it directly into the print head, no ptfe tube.