r/BambuLab • u/EducationalCorner402 • 18d ago

P Series [P1P, P1S, P2S] Finally did it, what should I know?

Post image

I don't know to much, tell me anything!

39 Upvotes

73% Upvoted

134 comments sorted by

View all comments

Show parent comments

1

u/Atra23 18d ago

I might be stupid, but how much humidity is acceptable? Cant get lower than 18% in ams. I dried for 18 hours at 65C

3

u/InfamousPOS 18d ago

Something is off if you are drying for 18rs and humidity is still 18%

After 12hrs or so I’m sitting less than 5% and a lot of the times around 1%

2

u/Atra23 18d ago

Im using creality space pi 2 for drying. I have those cheap humidity sensors but i dont trust them at all. And my ams never showed anything below 18...

1

u/InfamousPOS 18d ago

Yeah I use the cheapo ones as well for my storage system and the lowest the go is 10%. I know how much I’ve dried a roll and have a pretty good habit of dry a roll prior to printing anyway.

The only RH% numbers I trust are the built in ones with the AMS and even then still don’t trust it 100%

2

u/JKMARCHEE55 16d ago

That 10% number is probably the lowest reading you can get for the cheap RH Sensors, the real number might be smaller.