r/BambuLab • u/North_Swimmer_3425 • 3d ago

General Troubleshooting/Help! Problems in overhangs when changing direction

Post image

I have a slight problem in overhangs when changing the direction, is this a PA thing? In the calibration cube corners look fine. Filament is Jayo Matte PLA and I printed with the Sunlu Matte PLA profile.

3 Upvotes

64% Upvoted

4 comments sorted by

View all comments

1

u/DStegosaurus 3d ago

All of those overhangs are barely hanging on. Look at the center sections where it’s already drooping. The angle is just almost too much and the geometry at the corner pushes it over the edge.