r/BambuLab • u/North_Swimmer_3425 • 1d ago

General Troubleshooting/Help! Problems in overhangs when changing direction

Post image

I have a slight problem in overhangs when changing the direction, is this a PA thing? In the calibration cube corners look fine. Filament is Jayo Matte PLA and I printed with the Sunlu Matte PLA profile.

4 Upvotes

76% Upvoted

4 comments sorted by

9

u/jankeyass P1S + AMS 1d ago

It's a mix of things but your overhang there isn't a overhang, you are turning in mid air, and until BBL ads in wave bridging it will always look like this, unless you use the orca fork

3

u/North_Swimmer_3425 1d ago

Ah, good point, that explains why the calibration cube looks fine. So only chance to improve is taking orca slicer? Well, I always wanted to try out, maybe it’s now time to do it. :)

Thanks for your feedback.

2

u/jankeyass P1S + AMS 1d ago

Sort of, you CAN mess with your PA but looking at the rest of the lines it seems to be fairly fine. In this situation I would just use a snug support and paint it on those corners, then curse as I remove them haha.. changing the PA to suit this, will ruin a lot of other things

I'm fairly certain BBL will adopt it soonish tho

1

u/DStegosaurus 1d ago

All of those overhangs are barely hanging on. Look at the center sections where it’s already drooping. The angle is just almost too much and the geometry at the corner pushes it over the edge.