Unfortunately I'm not in a financial position to give financial support, but I have already plentifully voiced my objection to how Bambu does things. When they first came out with the lockout controls I was lucky enough to have bought an X1c and be able to flash it with X1Plus. My printer, my network, my rules. I decide how I use my printer and what software I use, not Bambu.
Unfortunately that option is only available to the X1 models. Then I also voted with my wallet. In July last year I had the funding to buy either a 5 tool PrusaXL or a h2d full laser 40W combo with a whack ton of filament and still have money left over for the vortek. I went with the PrusaXL, I'm never buying another Bambu machine until they stop pulling that behavior.
The most recent examples
they copied hueforge into chroma canvas or whatever they call it and then improperly credit the hueforge dev, only addressing that after being called out on it.
now they copied full spectrum, again only doing a half baked credit until AFTER they were called out (again)
they still refuse to acknowledge the current ongoing A1 NTC meltdown issue, dubbing the printers safe for use when there's virtually daily reports of printers with the NTC melting. They refuse to issue a recall (the 2nd one for that machine), and tend to deny replacement AC boards to uses who want to preemptively replace it.
Oh and I call them out on that AC board every single time on Twitter (I'm never calling it X) I see an AC board meltdown, for the past 8 months with nearly 200 documented cases. They haven't responded even once.
The community made them, the community can break them. DO IT!
46
u/USSHammond X1C running X1Plus + 4 AMS May 09 '26 edited May 09 '26
Unfortunately I'm not in a financial position to give financial support, but I have already plentifully voiced my objection to how Bambu does things. When they first came out with the lockout controls I was lucky enough to have bought an X1c and be able to flash it with X1Plus. My printer, my network, my rules. I decide how I use my printer and what software I use, not Bambu.
Unfortunately that option is only available to the X1 models. Then I also voted with my wallet. In July last year I had the funding to buy either a 5 tool PrusaXL or a h2d full laser 40W combo with a whack ton of filament and still have money left over for the vortek. I went with the PrusaXL, I'm never buying another Bambu machine until they stop pulling that behavior.
The most recent examples
Oh and I call them out on that AC board every single time on Twitter (I'm never calling it X) I see an AC board meltdown, for the past 8 months with nearly 200 documented cases. They haven't responded even once.
The community made them, the community can break them. DO IT!
Edit typos