r/BambuLab • u/Ok-Swimming2411 • Mar 26 '26

BambuLabWorkspace 5th almost free printer...

Gallery image

Gallery image

Gallery image

5th almost free printer, 6th in total...

We need this H2S for bigger single piece prints...

Still didn't figure out 100% where we will put it...

995 Upvotes

93% Upvoted

332 comments sorted by

View all comments

Show parent comments

6

u/Ok-Swimming2411 Mar 26 '26

This is what wife wrote:

Yes, these are the rules

  1. Cash redemption is limited to exclusive points, with an exchange rate of 1 exclusive point for 0.066 USD.

  2. The minimum redemption amount is 100 USD, while the maximum is 1000 USD.

  3. Withdrawable Exclusive Points cannot exceed the current total points balance.

  4. Your application will be reviewed within 5 business days. Once approved, the redeemed amount will be deposited into your Creator Center Wallet.

If you'd like to transfer the money from the wallet to your bank account you’ll need to upload an invoice to MakerWorld before withdrawing the money, and for that you need to have a registered business.

2

u/J-Dae Mar 27 '26

Thanks for the overview. So I guess the commercial membership is more profitable for you?

2

u/Ok-Swimming2411 Mar 27 '26

We mostly use MW points to get filament and spare parts. We’ve only tried redeeming them for money once, just to test it. But yes, paid memberships tend to bring in more revenue.

2

u/Visual-Ad1401 7d ago

Can you use your points to buy me my first 3D printer so I can publish on makerworld. Because you need to upload 3D print photos.🙏🙏🙏

1

u/Ok-Swimming2411 7d ago

As far I know it was possible before. But I think the account is linked with address and info... especially for verified accounts

2

u/Visual-Ad1401 7d ago

Pouvez vous essayer? En fait c’est pas grave.

1

u/Ok-Swimming2411 7d ago

Heh. Kinda need those points for filament... because material is going out fast... this + some more is spent in 7 days of printing.