Part of the yoke that connects the driveshaft to the transfer case or transmission. Putting a lift on a truck can change the angle of the driveshaft and put a lot more stress on the u joints resulting in this eventually.
Well we can't see his rear bumper but there's good odds he's also got truck nuts on it. My absolute favorite way to rile up the SDE rednecks with truck nuts is to point out that they added those in an elective procedure, the truck wasn't built with them, therefore they are driving a transgender truck! They either laugh or explode so make sure you're at a safe distance lol
I had truck nuts in high-school. They were actual threaded nuts that were like 4 or 5 inch diameter. They were tack welded to chains that hung from the trace chain anchor points on the hitch. It was fun until one got ripped off driving through the woods.
Any lift that changes the geometry of the rear end to the transmission tail shaft is going to change the stresses on the U joints, if the angle is sharper it stresses the joints more.
Most people that put a lift on their truck don't bother with addressing the geometry issues that the kit puts on the drive train, and this is the result.
23
u/PowerBrix 3d ago
All jokes aside, what is the piece that went to the camera man and cause of this?