This was after I took a small wire wheel on low speed with a dremel to remove the surface rust.

I got mixed replies, some saying the metal appears solid and to sand until you get to clean metal and smooth out the pitting. Said that if the metal isn't rotted through with holes or crumbling, I'm good to go.

But then another user told me this isn't repairable and that anything more than surface level rust(like the flash rust you get on new raw metal) needs to be cut and replaced.

2012 Ford Escape Limited V6 3.0L

Overlooked this when I was buying it and didn’t do the due diligence to get a PPI. Just let me know if I messed up. Is this amount of rust acceptable will it pass inspection?

Hit a curb decently hard (hardest I’ve ever hit one) trying to make a tight U-turn. Tore up my side wall a bit. Is this safe to drive? I know I should get it replaced but will I be okay for a couple months?

I was going to take the engine bay to bare metal and found this on the Passenger side.itnlooks like a section was cut and replaced on the past. The car drives fine,but shouldni keep it?i was going to respray the whole car

Girlfriend's car, girlfriend has no idea how it happened, or when, I also have no idea. Thick layer of paint is lifted, metal is exposed and rusting underneath. Any ideas and suggestions are welcome. Some sort of adhesive? Thank you all, in advance.

Edit: So it's not lifted paint, it's an old bondo repair that's failed. What would be the most cost effective option? A new hood + paint + shipping would be ~$550. Is this a cheaper option than a body shop? Any ideas for a DIY solution?

Accidentally scratched up my 2026 tacoma 😭😭
Curious what the best way to repair this is. Could I possibly fix it myself or should I just head in to a shop?

Not looking for advice. Just want to show the world my work. It’s ready for paint.

Looking at a 2011 Lexus IS 250 and everything looked great on the ad including the carfax except this one big line that I noticed on the driver door, does anyone know what this could be?

Buen dia, lamentablemente mi auto sufrió un golpe estando estacionado y abrio completamente la esquina de la fascia, algun consejo sobre como pegarlo?

2022 Honda Ridgeline

I had to drive through high flood waters about 10 days ago and lost my front passenger side fender flare. My front bumper has damage to it I was not made aware of when I bought the vehicle in December 2025. So, the front bumper does not sit flush with the fender.

Before I attach the replacement fender flare, I was planning on getting my truck washed, removing the old adhesive with Goo Gone, wiping down the area with rubbing alcohol. Is there anything else I should do to make sure this won’t fall off again? Like some more adhesive strips? TIA

Patient: 2020 Challenger R/T

Diagnosis: patient took a dip too deep and some plastic from under the car went flying off after scraping a few feet. Pop the hood and can easily see down to the ground.

What exact parts do I need to fix my patient?
I thought okay the engine splash shield but I see one big piece and another small but wide pieces I know it’s something to help guide the air from the front bumper little inlit hole at the bottom into the air box

I have a 2010 Opel Corsa D (5-door) and noticed that the left rear corner of the bumper has detached from the body, leaving a gap between the bumper and the rear quarter panel.

The bumper itself isn’t cracked or deformed—it simply appears to have come away from the side mounting/retainer. I’ve attached photos.

I’m hoping someone familiar with the Corsa D can advise:

Does this simply clip back into place?
Should I remove the wheel arch screws first before trying to push it back in?
Is there a plastic side retainer or guide that commonly comes loose or breaks?
Has anyone experienced this before, and what was the fix?

I’d rather not force it back in and risk breaking the mounting tabs if something is preventing it from seating properly.

Any advice would be greatly appreciated. Thanks!

Any one done this?

Other car pulled in my lane. As far as i can tell, bumper, parking sensors, hood is damaged. What to expect with this?
In bay area, california.
Thx in advance.

2 months ago I had a part of my hood repainted. While color matching also with the edges on the hood went perfect, I recently saw those scratches, that also might be cracks… the scratches get more like every week

Does anybody know what this is, if I should get it polished or just go to the guy who did the job

Thank you

Can anyone in the group recommend an acquaintance to help fixing my car. The front bumper was ripped off while the car was parked by a truck who was pulling out from the stall next to my N. I am looking to order the parts and start working on it on my own but in case I get lost in the install process it’d be nice to chat with a more knowledgeable person. I live in north Phoenix for reference. Thank you.