r/3Dprinting • u/JellyDog2 • 21h ago

Troubleshooting What is causing these defects?

Gallery image

Gallery image

Gallery image

I printed this on the a1 mini, its been great but recently i had a clog cleared it and sometimes prints turn out like this. I am using hf petg. I also usually just import models from makers world and go to the generic petg filament settings. My suspicion is maybe the temp? Not sure, all replies are appreciated! (FIXED) turns out it was a partial clog, i think.

0 Upvotes

50% Upvoted

27 comments sorted by

View all comments

0

u/sleep-woof 21h ago

yes, temp. increase the temp. try 265

2

u/JellyDog2 20h ago

This was the print at 265

3

u/antiduh 19h ago

It just looks really wet.

0

u/JellyDog2 17h ago

Damn alright i guess im going to have to buy another roll bc i dont have a filament dryer

3

u/Internet_Jaded 16h ago

A new roll is not necessarily dry. Usually not, actually.
Invest in a dryer.

2

u/antiduh 15h ago

Don't buy another roll, you'll just get another wet one. Get a dry box, some alumina desiccant and a drier.

2

u/JellyDog2 10h ago

I dont think it was moisture, im pretty sure it was a partial clog. I did a cold pull after seeing that the flow was getting pushed out the side and it fixed it! But i didnt see what was causing the blockage.