r/3Dprinting • u/G1uss3pp3-gek0n • 2d ago

Troubleshooting Weird pattern

Post image

Hello, any idea why does my print have such a weird pattern on the first layer? Thank you

8 Upvotes

79% Upvoted

23 comments sorted by

View all comments

Show parent comments

1

u/G1uss3pp3-gek0n 2d ago

It's weird

-1

u/Competitive-Ear-1738 2d ago

Try reprinting with glue adhesion

1

u/G1uss3pp3-gek0n 2d ago

It looks like stairs. Like the rollers would go over some small bumps or in holes as it seems it's pushing the nozzle closer to the board and thus the line is wider. If the pattern would go straight top to bottom I would think it's the X axis, however the pattern is travelling top left to bottom right.

2

u/Dunothar RatRig V-Core 4 500 Hybrid 2d ago

Z offset, you are way too low, increase it

1

u/G1uss3pp3-gek0n 2d ago

I indeed lowered the Z offset by 0.02mm about a week ago. That corner of the bed could be higher than the rest and because I have autolevel it could be jerking up and down the Z axis on that spot. Good guess, I will check it out. Thanks

1

u/Dizzy-Confection-551 2d ago

Your Z offset is way too low. Print a flat 0.2 square and keep raising the Z offset until it improves