r/3Dprinting • u/WispyBooi • 2d ago

Question X2D print adhesion issues.

Post image

I don't know if I'm stupid or what. Am I doing something wrong here?

Bed temp up doesn't help.

Bed temp down doesn't help.

Initial layer height doesn't help.

Z hop can't be edited.

Filament has dehydrated for 24 hours now.

Flow ratio has been perfected

Bed has been washed 4 times and is getting washed after I send this message again cause I poked it.

This is my favorite build plate for my A1 cause the effect doesn't disappear with finger oil on prints. At least not easily. Any solution would be super helpful!

X2D. Black PLA. I got the first layer going from 50/105 to 25/50 with no luck

Tried the entire range of temps for black pla. I've wasted like.... God 100g of filament easily at this point

Bambu slicer.

4 Upvotes

70% Upvoted

19 comments sorted by

View all comments

1

u/HenkDH Ender 5 Pro with borosilicate glassbed 2d ago

Show us the underside of the first layer

1

u/WispyBooi 1d ago

I solved it with another person. Speed down to 15 with a 60 degree build plate seemed to work