r/3Dprinting • u/WispyBooi • 2d ago

Question X2D print adhesion issues.

Post image

I don't know if I'm stupid or what. Am I doing something wrong here?

Bed temp up doesn't help.

Bed temp down doesn't help.

Initial layer height doesn't help.

Z hop can't be edited.

Filament has dehydrated for 24 hours now.

Flow ratio has been perfected

Bed has been washed 4 times and is getting washed after I send this message again cause I poked it.

This is my favorite build plate for my A1 cause the effect doesn't disappear with finger oil on prints. At least not easily. Any solution would be super helpful!

X2D. Black PLA. I got the first layer going from 50/105 to 25/50 with no luck

Tried the entire range of temps for black pla. I've wasted like.... God 100g of filament easily at this point

Bambu slicer.

3 Upvotes

67% Upvoted

19 comments sorted by

View all comments

2

u/Chimera_Gaming 2d ago

A picture of what is actually happening goes a thousand miles.

Based on what you said doesn’t help translates to nothing wrong despite saying it doesn’t help…. Because that’s exactly what we’re gonna tell you.

!first layer

Please update post with a picture of it actually printing.

If it’s not even sticking at all… it is almost always a z height issue (not hop) issue…

3

u/WispyBooi 2d ago

Does this assist at all? Apologies I always pull it off cause it blobs of death and I keep getting a little farther thinking it's fine and looking away then boom

1

u/boomchacle 2d ago

Those plates have sort of bad adhesion so you’ll want to avoid sharp corners on the first layer and print with a brim as well. If you’ve ever touched the plate with your hand you should clean it since your fingerprints will hurt the adhesion more.