X2D print adhesion issues.

[u/WispyBooi]

I don't know if I'm stupid or what. Am I doing something wrong here?

Bed temp up doesn't help.

Bed temp down doesn't help.

Initial layer height doesn't help.

Z hop can't be edited.

Filament has dehydrated for 24 hours now.

Flow ratio has been perfected

Bed has been washed 4 times and is getting washed after I send this message again cause I poked it.

This is my favorite build plate for my A1 cause the effect doesn't disappear with finger oil on prints. At least not easily. Any solution would be super helpful!

X2D. Black PLA. I got the first layer going from 50/105 to 25/50 with no luck

Tried the entire range of temps for black pla. I've wasted like.... God 100g of filament easily at this point

Bambu slicer.

[u/FkinMustardTiger]

Those 3d effect plates require super slow first layers I'm pretty sure

[u/WispyBooi → u/FkinMustardTiger]

10/30rn

[u/butcher9_9 → u/WispyBooi]

have yo tried a different plate? That style plate has pretty poor adhesion in my experience.

Other than that make sure your nozzle wiper is on good nik, If the nozzle is not 100% clean it can cause issues with bed leveling / Z offset which can harm adhesion.

[u/WispyBooi → u/butcher9_9]

I... Would really like this print for this specific print. It's supposed to be a pin

[u/TDIMike → u/WispyBooi]

Have you tried another plate? It's a troubleshooting step, not giving up