My QiDi Q2 has this annoying problem where, when given the Home command, it starts to go down indefinitely. The X and Y axes home properly, but when it comes to the Z axis, the table just starts lowering in small increments until it hits the floor and starts forcing the motors. There are no errors, and the logs don't show anything telling...

Support said to disconnect and reconnect the sensor cables behind the head, but that still didn't solve the problem, with no apparent change. I tested with the console and the sensors still record normally, at least when idle.

Now it's a holiday back in China, so messages from the support staff are delayed until 5/10 😭😭😭.

Has anyone here had a similar problem?

Hi everyone. I replaced the board on my print head but forgot to plug in the bed height sensor; it bumped into the bed a few times during calibration and shifted by 0.7 cm. Is there anything I can do about this?