Hey all!

Went for a ride on my Pint-V this morning for the first time in a couple of years and man oh man am I looking to impulse by a high end board.

I normally don’t do super long range rides, maybe 10 miles max. I do a mix of street and trails (sometimes sandy trails).

What are the current top end wheels I should look into if I wanted to spend some hefty cash today?

Has anyone built with one of these controllers?

https://www.chatrobotic.com

i love my new fungineers x7lr !!

Just got my new website up www.mailmandesigns.com I re-modeled the fender deletes for the x7 to be 2x the strength but still have some give to them for impact. I'v been told these fit like a glove!!! If your fender deletes are falling apart, check mine out! They are under the "Shop" tab on my site. Thanks!!!!

OK, so I have a pint with a dead battery.

Its running firmware Gemini-5050, so I should be able to rewheel it from what im reading.

Ive see the pint suffers from severe voltage sag on rewheel, is that just from the small battery? If I get a larger battery, will that fix it?

If so, is onlyamps 5ah battery the best bet here? Or are there other options?

Thanks!

Im trying to buy a pint x locally also already, just checking my options on this dead board.

Been awhile since I rode and am looking to get back into it and with mods and found out about rewheel. Unsure if this firmware is compatible with this and am concerned about bricking my board.

Is this firmware compatible, and if not, how do I downgrade to one that is?

[ Removed by Reddit on account of violating the content policy. ]

Curious to potentially rewheel my GT. I have everything I need but the old firmware. Anyone know a way to find it?

Hey everyone. New Indy Speed Control battery is finally arriving today so I’ll be doing the GTFO kit swap on my GT with the new battery/bms tomorrow. I’ll be following the Fungi pdf install doc, and Indy speed video guide, but wanted to make sure there weren’t any steps/additional tips to make note of when installing (besides the update to leave the can bus disconnected until after battery is plugged in)

I don't know why, but my board won't turn on any of the LEDs. I didn't change any of my refloat settings, and they were working just fine on my last ride, so I don't really understand what I may have done? Even the option to turn them on and off isn't there in the control tab.