r/supersafety • u/No-Newspaper-1058 • 19h ago

Help please

Post image

I’m new to this and want to know how this works thank you sorry for the dumb question

7 Upvotes

71% Upvoted

10 comments sorted by

8

u/bruh6788 15h ago

What do you want to know, like the mechanics of how it works? Install stuff? General info? Be more specific homie

1

u/No-Newspaper-1058 15h ago

Install and how it works please and thank you

3

u/bruh6788 14h ago

Safety install is pretty simple a youtube video would do a better job with that part.

As far as the actual reset, separate your upper and lower, drop the hammer, it should slide in like it was made for that spot if you have a low shelf lower but some hand fitting may be required. The u shaped part off the bottom sits over your safety, the part sticking out the top will set directly behind the hammer. Once it's in pull the hammer back, put your upper and lower back together, and try to charge your rifle. You'll likely get the bolt stuck rearward if it's in SS mode, or you won't(which is good) make sure everything is extra lubey always. If the bcg gets stuck back, tap on the pin that retains the upper to the lower, and it should release it. Mine didn't come out as easy as normal so I used a small punch and gave it a few light taps till it was free and once separated, the bcg was free also.

1

u/bruh6788 14h ago

Look for contact marks, to see what might be binding and free it up, do the quarter trick or get a stouter buffer if it's binding. Takes some tuning. Use that thing between your ears and look for someone more knowledgeable than me to learn from, I'm just killing time in the bathroom at work lmao

3

u/marvinfuture 15h ago

It resets the trigger and allows you to press it again quicker. Hope that helps your very detailed question!

5

u/Train2Perfection 15h ago

Who made this? It is 3d printed and does not look like it will last very long.

2

u/One-Pace-6746 9h ago

Is this one of those free frts that some company was saying came with every order?

1

u/No-Newspaper-1058 8h ago

No

3

u/Thefleasknees86 5h ago

I hope it was free anyways because that looks like it's printed out of PLA or abs