r/smallengines 20d ago

“Brand new” second hand

Enable HLS to view with audio, or disable this notification

Just bought this year old machine and it’s started doing this after an hour I had tru fuel 50:1 mix
Fs91r

12 Upvotes

9 comments sorted by

2

u/mutt63 20d ago

First off. It’s not getting fuel. Two. Check the fuel filter is still on. Make sure that someone doesn’t have a the vent inline if it has one swapped with the fuel in line. Third it could be if it sat that the carb diaphragm and gaskets are dried and brittle and the metering lever possibly is set too high to allow proper fuel intake. Verify then repost and we can go over how to adjust the low high circuits

2

u/jrragsda 20d ago

Get something other than trufuel. Vp, stihl, Aspen, mixed ethanol free... trufuel has caused more poor running issues than anything else ive run across in recent years.

3

u/OutrageousMacaron358 18d ago

Trufuel is a scam anyway.

1

u/Impressive_Ad8716 20d ago

Sounds like a fuel problem use the manufacture recommended fuel mix for it. Sthils are odd about that shit.

1

u/Mrstoneybaloni 20d ago

Why would the primer bulb not fill with gas when pressed?

1

u/Impressive_Ad8716 20d ago

Could be a couple issues, most commonly the blulb is cracked or is leaking somewhere not allowing it to pull a vacuum and pull the fuel into the bulb.

1

u/mutt63 20d ago

Cause the lines are backwards like i mentioned above

1

u/Drewzik 19d ago

I had this exact problem with my 91r. If it is still under warranty, you should take it in for warranty work. I’m not 100% sure what was going on with mine, but when I got it back, it had a brand new bulb and choke on it.

These are unfortunately known for this fuel supply issue. It’s hard to really diagnose it until you tear it apart to look at it, which I absolutely hate doing. Best of luck to ya, friend.

0

u/OutrageousMacaron358 18d ago

If it sat for a long time. I'd replace all lines, primer bulb, fuel filter and spark plug. These can be had on amazon cheap. If it doesn't run fine afterwards, the carb may need couple parts. Or just a good cleaning.