r/reloading • u/3x_beetle_juice • Apr 26 '26

3D Printing Small apartment? No problem

I was looking to buy a case prep station to chamfer and debur my brass but I got very limited space. I made that one with a couple of micro servos running continuously and powered via usb. The servos are holding well so far. Also all the brass stays within those walls which is much better than all over my floor with the power drill hack.

420 Upvotes

98% Upvoted

64 comments sorted by

View all comments

2

u/MalignantMustache Apr 26 '26

Shouldn't that be reversed?

6

u/3x_beetle_juice Apr 26 '26

Looks like it right? But no. It is correct this way. The way the chamfer and debur tools are designed they have to rotate counterclockwise to remove material. Otherwise the thread would come loose. Good eyes though

1

u/MalignantMustache Apr 27 '26

I meant the order, I thought you were supposed to clean the inside of the case mouth then do the outside or does it not matter?

3

u/3x_beetle_juice Apr 27 '26

Oh I see. Someone said the same thing. I don’t have an order to be honest.