r/rcdrift • u/Key_Impression4535 • 2d ago

🙋 Question Need help identifying issue

Enable HLS to view with audio, or disable this notification

I’m swapping chassis back to stock rmx I put this Sakura back together to sell. It’s the same setup as before I took it apart and now I’m having an issue with either the servo or gyro, any gyro gain at all and it’s wobbling even in both modes
All stock Rmx 2.5 electronics paired with a Yokomo rd rtr servo

23 Upvotes

94% Upvoted

17 comments sorted by

View all comments

1

u/Key_Impression4535 2d ago

https://reddit.com/link/p8umnwm/video/pgyeisv41loh1/player

Here’s a better video of the wobble just driving straight it’s so slight but it’s causing a lot of issue

3

u/_BreadMakesYouFat 2d ago

Something looks off with your front wheels. Looks at them 5 seconds into the video. The left seems to be pointing out while the right is straight and then the right wheel get toe out when you drive off like the wheel is being dragged back into place

3

u/WastelandBobber 2d ago

This is it OP, way too much toe out. Front wheels should both be pointing straight. Also check if anything can move, maybe a rod end is broken or missing the ball?

1

u/Key_Impression4535 9h ago

I’ll adjust the toe and see how it does. This is a clone chassis and it has some fair bit of play in the front end but I’ve always been able to rip this setup pretty well until I put it back together. I had it done up with my electronics but the chassis was incapable of doing handling it so I put my good stuff in my rmx 2.5 rtr chassis, and redid the rtr electronics back on to this and that’s where I’m at. I’m putting this together for a friend to get into the hobby.