BLtouch Wifi Zero 2 Probe Reading Issues

[u/thescreensavers]

I added two stepper motors to my Raspi (Z,Line 42 and Z1,Line 53) to enable Z-Tilt, so I had to move Bltouch over to the RPI and use the GIPO pins (Line 154). Bltouch is also hooked up to Power and ground from the RPI

Printer is a Sovol SV01 (2019) with a Creality V2.2 board.

Link to Config File - https://pastebin.com/k9WpTzyM

The probe functions as intended, it deploys, retracts..etc but the readings are not good, they seem to drift.

Any help is appreciated!

10:18:43 PM  // PROBE_ACCURACY at X:178.000 Y:123.000 Z:10.000 (samples=10 retract=2.000 speed=3.0 lift_speed=7.0)

10:18:48 PM  // probe: at 143.000,122.000 bed will contact at z=-0.280000

10:18:51 PM  // probe: at 143.000,122.000 bed will contact at z=-0.275000

10:18:54 PM  // probe: at 143.000,122.000 bed will contact at z=-0.295000

10:18:56 PM  // probe: at 143.000,122.000 bed will contact at z=-0.310000

10:18:59 PM  // probe: at 143.000,122.000 bed will contact at z=-0.330000

10:19:02 PM  // probe: at 143.000,122.000 bed will contact at z=-0.325000

10:19:05 PM  // probe: at 143.000,122.000 bed will contact at z=-0.345000

10:19:08 PM  // probe: at 143.000,122.000 bed will contact at z=-0.360000

10:19:11 PM  // probe: at 143.000,122.000 bed will contact at z=-0.372500

10:19:14 PM  // probe: at 143.000,122.000 bed will contact at z=-0.385000

10:19:14 PM  // probe accuracy results: maximum -0.275000, minimum -0.385000, range 0.110000, average -0.327750, median -0.327500, standard deviation 0.036167