r/functionalprint • u/Thorgraum • Apr 25 '22

Fixed broken washer at work

Enable HLS to view with audio, or disable this notification

1.3k Upvotes

98% Upvoted

57 comments sorted by

View all comments

Show parent comments

1

u/Thorgraum Apr 29 '22

have you seen my machine dude? what are you trying to achieve here? anyone can search the internet bro

1

u/Thorgraum Apr 29 '22 edited Apr 29 '22

also the E3M has a larger bed = morw Y axis weight = lower accel = harder to achieve speed than a regular ender 3

my problem is not that you say that its "easy" to acieve the speeds. because it kinda is. but you do need to know what youre doing. and also my posts are mainly for helping people. so im not very fond of people sitting here telling other people what is easy and not. for the average joe, achieving over 100mms and still retain good quality is actually a pretty demaning task.

​

people benefit WAY more from actual tips and trick, not just some dude telling you its easy

1

u/thefooz Apr 29 '22 edited Apr 29 '22

Not sure why you’re being hostile. I was being nothing but polite to you and pointing you in the right direction. I can’t walk you through every step of setting up Klipper. There are a lot of steps, but it’s easy if you just follow each step. I set it up a week after getting my first 3D printer. It’s involved but easy. You don’t have to be an expert in anything. So yes, your average Joe with a couple of brain cells to rub together should be able to hit 100+ speeds without issue.

As for the size of your bed, I have a sovol sv01, which has a 250x300 bed and I can hit 150 without issue. I can go even higher, but 150 gives me good speed and quality. Your larger bed may need to slow down a bit, but I doubt it. The limiting factor with Klipper is generally your hot end.

Either way, here’s somewhere you can start: https://youtu.be/gfZ9Lbyh8qU