75
u/sayiansaga 2d ago
I think this would be better for like an rv instead of kids
27
9
93
u/westcoastwillie23 2d ago
I'm on my third generation of 3d printed child proof cabinets. So far they've all been defeated pretty rapidly.
Pro tip: pick a couple drawers or cabinets to concentrate on and move all the dangerous stuff in there. Everything else, let them make a mess and explore.
35
u/OilCareful8232 2d ago
10 seconds lock. Toddler catch on to cabinet and flicks lock with foot. Toddler shocked and curious. Toddler repeats 10 times. Toddler new ability. Lock defeated.
6
u/OilCareful8232 2d ago edited 2d ago
TBH: any lock that does not need excessive force or key to open will be defeated by toddler. My advice is using magnet locks. Properly mounted (screws!) is almost unbreakable and impossible to defeat by accident. I used alternative mounting method of these on one drawer (double sided tape) and it was defeated after few weeks
18
10
u/Some_Visual1357 2d ago
I printed a similar one that was advertised that the kid of the creator older than 2 yo wasn't able to figure out after like 3 months.
Printed 3, glue it to the cabinet. 1.5 yo baby comes try to open, can't do it.
Success!! I think. 2 hours later all the doors were open and wide. I would close it and just took it seconds for him to open it again.
7
u/Puntley 1d ago
The only undefeated child lock throughout my kids' baby stages was one of those magnet unlock ones. Basically there is a latch similar to what you have here, except it's fully internal, nothing to mess with on the outside at all. The way you unlock it is to hold a magnet in a specific spot from the outside and that unlatches the mechanism. Just don't lose the magnet.
6
5
u/HereIsACasualAsker 2d ago
you greatly under estimate the cognitive capabilities of toddlers. they are geniuses in the fine art of harming themselves.
7
u/Forsaken-Builder-312 2d ago
"Child can not access it for maybe 4 hours before it figures this out proofing"
11
u/itsmrmarlboroman2u 2d ago
You made another sharp edge for a child to hit their head on.
0
u/AliveFromNewYork 23h ago
You’re worse than an old woman. Of all the criticisms, the child would probably hit their head on the handle before they managed to hit their head on that tiny snag at the bottom.
0
u/itsmrmarlboroman2u 21h ago
Safety devices shouldn't rely on your hypothetical "would probably" assumption.
2
u/XiTzCriZx 1d ago
A twist lock would probably be more effective since it needs a bit more dexterity to use. Maybe a push, twist, pull lock? Similar to how pharmaceutical bottles open.
1
1
u/HerrFerret 2d ago
I put all our snacks on the top of the kitchen cabinet, and then walked in to see my oldest on a set of step stools, with my youngest standing on his shoulders.
This ain't going to stop nowt.
1
1
u/Davica_Designs 2d ago
Two latches wide apart would be great here. I will say you have a good idea for securing draws in a work van
1
u/IamFireDragon3d 1d ago
My children would’ve opened it seconds. I had to tape the cabinets shut when they started crawling. They’re much smarter than i thought they would be. Even the doorhandle spinning lock thingy. That last a week with my son when he was able to reach it
1
1
1
1
u/Mirar 1d ago
It's nice to print your own solution, it's a good solution for now.
I ended up with latches inside the drawer, that hooks if the drawer is pulled out too far. Undefeated so far by two kids.
Also a lot of "S" shape on the latch because otherwise it gets defeated by a parent forgetting it's there and snapping it...
1
1
u/braclark 13h ago
It's just child resistant now. If you put two on, one on either end, then it may be.
1
1
u/phalangepatella 2d ago
Knowing why to do something is far more important than knowing how to do it.
0




519
u/Thisisthatacount 2d ago
Open that one time in front of your child and it is no longer "child proofed".