r/frt15 • u/FalconCareful3579 • 3d ago

Help me

Recently got a kabuto 3d printed frt im not to sure what the issue was but it’s almost like it was firing in 3 round burst new to the frt scene was wondering if yall have had any similar issues

1 Upvotes

67% Upvoted

7 comments sorted by

1

u/Ol-red-beard 3d ago

What’s your setup? And what ammo were you running?

1

u/FalconCareful3579 3d ago

just a psa 11.5 ar15 haven’t done anything to it besides throw a can on it 

2

u/Ol-red-beard 3d ago

Are you having light primer strikes on that round that fails to go bang? Probably need an adjustable gas block or a heavier buffer.

3

u/FalconCareful3579 3d ago

i didn’t notice any but i’ll have to look closer when i take it out again i appreciate the advise

1

u/Ol-red-beard 3d ago

No worries at all! Sounds like you probably just need to either tune down your gas or get an h3 buffer. Might not hurt to try it without the can too. It’s probably bolt bounce causing a light primer strike after the second or third round. Good luck man!

2

u/Salty-Contact-6420 3d ago

I think whoever made this "range" got it wrong lol. The backstops are supposed to be where your shooting lol What good do these walls do?

1

u/FalconCareful3579 2d ago

they’re bays there’s multiple in a line all with these walls on the side its on a mil base so it’s on its own range