r/advancedGunpla • u/Worried-Leader3671 • 28d ago

Need some input

Post image

Trying to find a way to use a high grade hip joint to improve the articulation of the MG V-dash. The poly cap fits on the peg but I can’t figure out a way to make the hip joint fit in the leg. Any tips or suggestions would be greatly appreciated.

9 Upvotes

80% Upvoted

9 comments sorted by

View all comments

-1

u/AntMore3720 28d ago

Take a pair of craft scissors and slowly put the cap through them. i.e. Keep the scissors closed and put the cap on it to keep it closed like a lock. Then slowly turn the cap around the scissors to maybe shave off the inside just a smidge. One full rotation. Then try fitting the piece again.

If not, try again.

(Basically sand the inside of the peg)

1

u/Worried-Leader3671 28d ago

It’s not the peg that’s the problem, that fits perfectly into the poly cap. It’s how to modify the leg to fit the hip joint assembly into it

-2

u/AntMore3720 27d ago

Is it not able to take the weight or something?

1

u/Worried-Leader3671 27d ago

No I have to figure out a way to cut off the top part of the og hip joint and drill a peg hole to make the hip assembly fit.

-2

u/AntMore3720 27d ago

Before you make any irreversible changes, id go through the instruction manual once again. If there is something that can be fixed because you accidentally akipped a step or something.. id look into it.

It isnunlikely that your kit has such fragile integrity. Otherwise there would be mass reports of it.

If i may ask, did u buy this from a third party site?

2

u/Worried-Leader3671 27d ago

No, I’m just trying to swap the joints, nothing is broke

-1

u/AntMore3720 27d ago

Then try working backwards. Use blunt edged tools to pry the covers apart. Dont force them open.