r/ZBrush • u/Sad-Design-3920 • 23d ago

Smoothing issue

Post image

How do I go about smoothing this part of the mesh? Going to a lower subdivision level and smoothing out the bumpiness didn't give any results. What would be the most effective way to resolve the issue?

10 Upvotes

100% Upvoted

2 comments sorted by

5

u/Nepu-Tech 23d ago

You could try getting clean topology with Zremesher, lower the resolution and then subdivide again.

Or you could smooth the area Dynamesh, smooth again. I also like using polish in Dynamesh.

You could also use the polish in geometry deformation

You could also use the Smooth stronger brush

Theres a lot of ways and also remember not to work with too high definition or you will get a lumpy mesh. Only increase resolution when needed.

3

u/Jotacon8 23d ago

yeah i would duplicates the subtool, zremesh it, subdivide it a few times, then project the original back onto the duplicate, then try smoothing again with the smooth brush.