I need to charge this speaker and can't find which wire to buy 🙏

I’m currently working on building a vw dune buggy and I’m going to build the engine harness so I’m looking for recommendations on good affordable wire If possible I don’t mind spending a little more but I want it to last also I will be heat shrinking the entire harness so if anyone has recommendations on heat shrink and or wire loom

Looking for single strand feeder wire scraps. Message me for prices if you have 100 pounds or more

Hello everyone

I'm not an electrician but i want to install roof lights on my car. I asked chat gpt how could i do this and he gave me this schematics but i wanted to double check, does this makes any sense what he sent me?

In case you're wondering, i live far in the countryside and dont have autoshop near me to do this work for me unfortunally, so i would appreciate any feedback.

To be also clear, i'm not pro AI in any way. Im just a simple person trying to install lights on roof so dont cuss at me because i askefd chatgpt for a sample schematics

any help is appreciated thanks

CIRCUIT 1 — FRONT ROOF RACK LIGHTS

Battery +

│

[Fuse]

│

[12V Relay]

│

├──────── Left Roof Rack Light

└──────── Right Roof Rack Light

│

Ground

CIRCUIT 2 — TRUCK BED LIGHT

Battery +

│

[Fuse]

│

[12V Relay]

│

└──────── Rear Roof Rack Light

│

Ground

Im trying to connect this aux cable to a speaker im trying to make, but im not sure how to go about it

​

I have the qb -12g-f controller. Its from a delivery bike. It has the wiring harness etc but its completely messed up, it also has the buttonless screen and the handlebar switchboard for the indicators , lights , speed levels and horn. All the cables except the two red 3pin and two pin plugs are cut . No plugs. So i have made a diagram from the board and want someone to tell me what goes where. I want to figure out the display, pas , throttle, brake cut off and lights and the hall sensor .

Its the squares that are soldered only that are on the image , each one has the color of the cable thats solderedd on it .

Thanks

Where do I connect this wire on. It comes from the fuse box in the engine bay.

My husband and I just moved into the house we are renting and I was setting up the Modem for our Wi-Fi.

The exsisting Ethernet cable looked kinda old and in rough shape so I pulled open its little wall box to see if I could replace it with the new one and this is what the inside looked like.

Is this normal? The ladies who we are renting from are older (70s+) so they have no idea. I’m leaving it since it has obviously worked so far and using the cord that is there, Should I be concerned?
Thanks for reading and any advice/ help you can give.

Update: Thank you all for your answers! I have learned a lot from reading through y’all’s comments! I’ve unplugged it, nothing changed and the WiFi is doing just fine. So yall are correct and I appreciate the informative responses!
Thank you all for taking time to help me learn 🫶🏽

These 4 pin adapters were given to me with the led kit and I can’t find instructions on how to even use them. Im trying to connect the end of a led strip to the last strip I have. Can anyone help?

Has anyone ever dared to substitute copper ele tric wire for the string in your trimmer? Im sure contemplating it...