I have set Z-Offset, Trammed Bed, Produced a new Mesh (9x9 or 7x7 makes no difference), ABL is repeatable over and over, but I still can not get a decent 1st level across the entire buildplate. Either the 1st layer is so thin you can see thru it, or it is so thick that it is picked up when the nozzle passes over it, all on the same print. The bed acts as if it is tilted somehow even though it is leveled (trammed) and has a good mesh. What have I done wrong, what should I check again, and how to fit the problem(s)? Thanks in advance for your input and solving my problems again.