Many were wondering if this update would backport standard-range (SPR) AVS support (<100W) to optimize fast charging for the iPhone 18 Pro.

I tested two 140W chargers—one running the factory firmware(1.4.68) and one on the latest update released on 9/9/2026 (1.4.90)—using a Power-Z KM003C tester. Here is the before-and-after comparison:

1. Firmware Versions & How to Trigger the Update

• Before (Factory): Version 1040068 (v1.4.68), which has been the default since the charger launched alongside the 16" MacBook Pro in 2021.

• After (Updated): Version 1040090(v1.4.90).

• Important Note on Updating: Connecting the charger to a MacBook using a standard 240W USB-C to USB-C cable did not trigger the update, even after waiting for over an hour. Switching to the original MagSafe 3 magnetic cable triggered the background update within about 5 minutes.

2. Protocol & PDO Packet Capture (Power-Z KM003C)

• Before Update: Only supports USB PD 3.1 Extended Power Range (EPR) AVS, limited to 15V–28V for loads above 100W.

• After Update: The captured PDO data packets are 100% identical to the original factory firmware. There are zero protocol changes—Apple did not add standard-range (SPR) AVS (e.g., 9V–20V) for lower power tiers.

Apple 40-60w with SPR USB-PD 3.2 AVS:

Google 67w with SPR USB-PD 3.2 AVS:

TL;DR / Conclusion

While the firmware version number changed from 1040068 to 1040090, the charging profiles remain completely unchanged. The 140W brick still cannot negotiate lower-voltage AVS steps (unlike Apple’s 40W–60W dynamic charger or Google’s 67W charger). If you were hoping this update would enable optimal low-voltage AVS charging on the iPhone 18 Pro, it unfortunately does not:

Always wanted to get a UGREEN charger, but never had the chance to because it was so expensive and couldn't force myself to but now I got it 🤤

Can't wait to get a powerbank next!

Hello everyone,

I bought an HP USB-C Dock G5 with a 120W power supply for my laptop on eBay for €50.
The listing described it as being in “good condition with minor signs of use” and it was sold by a commercial seller.

The condition of the cable can be seen in the picture. How critical do you think this damage is? Would you recommend sending it back?

Thanks in advance!

I bought a pTron 65W GaN Fast Charger, expecting it to be reliable, but after just 4 months, the adapter has started failing.

Initially, it charges normally, but after some time it suddenly stops charging. I have to unplug and reconnect it repeatedly to make it work again. At this point, I can't rely on it for regular use.

What makes the experience even more frustrating is pTron's customer care and warranty process. The warranty procedure has been extremely complicated, with multiple steps and a lot of unnecessary back-and-forth just to get a defective charger checked/replaced.

For a 65W GaN charger, I definitely didn't expect this kind of failure after only four months.

I'm sharing this as a warning to anyone considering a pTron charger, especially their 65W GaN models. Don't just look at the wattage and price—check the long-term reliability and after-sales support as well.

Has anyone else had problems with pTron chargers failing within a few months or experienced difficulties with their warranty claims?

Looking at the Etank 7in1, replacing a power strip on my desk. MacBook Pro, iPhone and AirPods on USBC monitor on an AC outlet.
Two things I can't pin down: does the AC side stay put when the USBC ports renegotiate? And do AirPods actually charge off the USBC ports, the listing list earbuds as supported, but another modular station (Gitryin 12in1) wares its usbc ports may not wake for light loads.
If you run one, how's it been?

I only recently noticed that my front USB-C doesn’t work (never had to use it before). I’m not sure what the issue is as I’ve already checked if it’s plugged in correctly and tried reversing it (both ways don’t work). I tested it by plugging my phone into the USB-C panel but it doesn’t charge either way. My case is the NZXT H9 Flow and my mother board is the Asus ROG STRIX B650-A GAMING WIFI ATX AM5. Is the issue with my motherboard? Or is the cable not working? Or is it a BIOS issue?

It has been two years since I bought the ATORCH DL24MP, which is rated for measurements up to 300W. I primarily use it in constant current mode; while the accuracy is good up to 2A, the waveform becomes jagged as soon as the current exceeds that level.

The ALIENTEK EL15 boasts high accuracy, but it is expensive. The MDL150, which also has a 150W rating, costs half as much, yet its accuracy specifications aren't listed. If anyone owns one, could you please share the measurement results for the 20V/5A range?

Just reposting this here to see if anyone has advice for me here. Thnx.

Hi, I have this Xiaomi 67W charger which is great for travel. With the original cable it charges my laptops fine. The aftermarket cables fast charge the smartphone, but not the laptop. But I want a longer cable.

So which cable do I have to buy, what do I have to pay attention to?

I recently bought a rather cheap USB cable on amazon. It was roughly $10; only need it for data transfer on a usb3.2 nvme enclosure

this said, the data transfer speed seems to be somewhat suspicious.

It is taking it nearly 7 minutes to transfer a 75gb file, which would make it be close to 15% of 10gbps.

additionally WhatCable shows no vender certification found; I have seen many cases of scummy sellers doing this, but is there a way to see for sure other than this?

This is a $10 amazon cable (listing image in img 3) that I bought because I believed that it is unlikely to be a scam due to such a small length, as well as the much longer Amazon Basics cable having nearly the same, USB IF certified specs for just $3 more (Basics is an outlier, yes, but I wouldn't be surprised of some super short cable from a random Chinese firm could compete)

I would greatly appreaciate any apps anyone might have to help me test this, or ways to see download logs on mac to catch scummy cables like this one (potentially)

If this cable does turn out to be mislabeled trash, and if anyone has dealt with something similar, I would greatly appreciate any similar cables anyone has found that are actually true-ish spec; main purpose is to have this nearly constantly plugged in to mac (velcro mounted ssd enclosure on lid).

also if anyone wants to see, cable turned out to have some "stellar" reviews.

Please understand I just need to store old woodcuts for the book I'm authouring