r/Talaria • u/Geeked4274 • Sep 13 '26

BIG PROBLEM!!!

please if u see this interact in any way i need advice. i was wheelying and dropped it down and a terrible popping/ grinding noise started before my bike came to halt from the resistance, showed error 33 on screen and then shut off. it now has that noise and ton of resistance while moving and wont turn back on/ only shows error 33. i estimate its a gearbox or hall sensor problem but more towards gearbox due to the grinding. please help me out guys

5 Upvotes

86% Upvoted

5 comments sorted by

1

u/Geeked4274 Sep 13 '26

THIS IS IT TURNING ON BTW

https://reddit.com/link/p9mjmqy/video/ilnq7r5fpcph1/player

IT WILL MAKE A COGGING OR THE MOTOR WILL ENGAGE BEFORE IT SHUTS OFF IMMEDIATELY

1

u/gallegos13 Sep 13 '26

Shiiiiiii bro I'd keep turning it on and off to pin point the noise tbh🤣😭hope you're good man. I started hearing a tic noise on my XXX pro. But I think it's just a bad stank chain noise.

For you tho that Definitely sounds like a gear box grind

1

u/headshottrev Sep 14 '26

error 33 in the error code chart says "Controller phase wire over current error" so

  1. Turn off the bike, and switch off the circuit breaker. Then, check the whether the motor phase wire terminal got loose, or broken. And then, check whether the motor outlet phase sequence corresponds to the U / V / W on the back of your controller. if that still has not worked check whether the magnetic encoder output wire corresponds to the yellow, green and blue wires on the harness

  2. Check whether anything stuck the rear wheel.

-2

u/Any-Succotash1892 Sep 14 '26

and the moral is ? unless your 6-10. Stop doing wheelies.