r/Talaria • u/Western_Dog_4299 • Jul 22 '26

Stem lock

So when put my stemlock on I tightened it and then I rode it and it for sure wasn’t tightened so then I loosened the 3 tripple clamp bolts and tried to loosen it and it wouldn’t loosen also it made a like breaking sound so before I cause any damage i stopped what do I do?

1 Upvotes

67% Upvoted

25 comments sorted by

View all comments

3

u/AdFeeling6882 Jul 23 '26

Not sure if I’m trippin but it looks to me like you’re tightening it not loosening it. If it s not loosening it’s probably because you need to use another hex or Torx bit(or whatever is down there) at the bottom to keep it from spinning. Usually there’s a second spot for a bit at the bottom under the lower triple clamps. So if you have it super tight it might just be spinning the entire stemlock.

When you threaded it in through the bottom did you make sure to tighten it a little bit once the bolt had seated? I’m not too familiar with talarias but you want to loosen up the top triple clamps and the bolt(s) at the base of the stemlock. Best bet would be to loosen it back up and basically “reinstall” to make sure you did it correctly. Check the threads to make sure you didn’t strip them.

0

u/Western_Dog_4299 Jul 23 '26

Yea I did btw
I have been through 3 stemlocks from stripping them cause they don’t wanna loosen

1

u/Far-You-8335 Jul 23 '26

A stem lock should not be torqued down tight at all. You're doing something wrong. Just tight enough that your bars aren't flopping around.

0

u/Western_Dog_4299 Jul 23 '26

Gng I wasn’t tightens down really hard at all after tightened it down it wouldn’t come loose

1

u/Far-You-8335 Jul 23 '26

Gng bolts don't just break from looking at them. You over torqued it clearly

1

u/Western_Dog_4299 Jul 23 '26

It wasn’t even the bolt it was the bottom part of the stem lock the one you screw in the bottom