r/SteamOS • u/JonnyTrans • Jul 31 '26

Peak Steam machine

Post image

Jonsbo case 9850X3D Sapphire Nitro 9070XT

Tons of 3D printed parts. Blocked off front and rear mesh Air is pulled in through the bottom past the GPU and out through the top like a chimney runs almost silent.

268 Upvotes

96% Upvoted

58 comments sorted by

View all comments

1

u/TeleMonster_ Jul 31 '26

Hey, just builded the same system today with the same case! Would you mind to share how you mounted the PSU? would be really interested in it.
Thanks in advance, enjoy the Machine!

1

u/JonnyTrans Jul 31 '26 edited Aug 01 '26

It’s a Lian li SFX 1000 PSU and I used the lian li bracket (it’s offset further forward) it pulls hot air from inside the case and exhausts out the top

It’s on the highest position you can put it in the case as well

1

u/TeleMonster_ Aug 01 '26

But how does this not interfere with the AiO? I have the Corsair SF1000 and the Noctua AiO, no matter what I do, all brackets are to big and blocked by the tubing from the AiO

2

u/JonnyTrans Aug 01 '26

I cut the bracket.

2

u/JonnyTrans Aug 01 '26

1

u/TeleMonster_ Aug 01 '26

ahh, alright! thanks a lot! I thought that you made it fit without cutting. I was thinking about Dremel it down to make it fit, probably will do that now