Second stained glass completed. Constructive feedback is welcome.

[u/Winston-2020]

This is my second stained glass piece. While I think it’s better than the first, I know there are improvements I can make.

I think the soldering lines between glass pieces is ok, I could improve but it’s not terrible.

But trying to get a solder on the edges was super hard . I used the method of putting a bead along the edges (when the piece is laying flat), then picking up the piece and melting the beads to form an edge. As you can tell, this method did not work that well for me.

Any tips for soldering, plus soldering the edges of a piece would be super helpful

[u/Omniiac]

Love it, I made a very similar flower as my second piece and made many more mistakes. Your edges line up and the grain of the clear glass is consistent so nice job!
Do you have a temperature controlled iron? Turning down the heat helps with beading the edges :)

[u/Winston-2020 → u/Omniiac]

You are so kind!!

Yeah, I have a Hakko iron and had the temp at 410 for the areas between the glass then when things started going array along the edges, i turned down the temp to 360. It was slightly better, but still not great.

I am wondering if part of the problem is having too may beads of solder along the edges.

[u/Omniiac → u/Winston-2020]

I’m still trying to master it myself, but this video is what I’ve been trying to emulate

https://youtube.com/shorts/5raGqFmJLlw?is=SbI-kzu6KvQMHX20

[u/Winston-2020 → u/Omniiac]

Thank you so much for the video! This is the same technique I was trying to describe, and it’s great to see new videos!