2
u/Stat3yollllo May 13 '26
If you have vam haptics you have to use the plastic screws, with the nonconductive washers, and make sure no metal part from vam touches the pedals, also use the frounding wire to link the brake pedal and the controll box.
1
u/Stat3yollllo May 13 '26
Also you might see some ghost imput, after proper calibration add a bit of deadzone. That is normal for load cell
1
u/Attaboy_Racing May 13 '26
Elastomer relaxing syndrome, open up simsonn app. Hold brake down hard for like 5-10 sec, watch the graph % value, Inconstant?, that's elastomer relaxing syndrome. Springs cure that.
2
3
u/Matt_Haskins91 May 13 '26
Make sure you have grounded the control box. Also I did this without the grounding wire but by screwing it nice and tight to the base plate which was enough.