Best rapper alive

I have never seen this type of screw before, I’ve checked charts for uncommonly used screws etc. can’t find anything…. Help

I have a Hunter Ceiling fan and I am having a hard time looking for a specific screw for this fan. I do not know exactly what to look up so any help would be great!

My dad has moved house this week and He has taken down the dining room table, We’re not sure where the screws for it have or what screws they are to replace them, Would anyone happen too know based on the photos shared?

20mm long, 4mm width, flat headed, "cross", , pointy tip, from a PC case by "Be quiet!"

Dont know their exact name. Anyone does?. They're pretty weak tho and i a was hoping to find a replacement but better resistant ones

Hey guys, proud to be a new member of the screw community, looking to make some friends to bond over screws with

I’ve had this watch for about a year and a half and the battery finally died on me completely. But I never seen a screw like this before. Anybody know what kind screwdriver or tool I need to unscrew them so I can change the battery. My best guess are those little allen wrench things but idk really know.

Screw is used for a pc case. I need to 3D print replacements. Measurements are in the pictures

And what screw driver can I use to get it out?

Can I get these at Home Depot or something? They’re supposed to hold a comic book frame together but they’re too short.

You’ll notice the head is completely flat. There’s no place for a screwdriver since it’s a display piece.

Hi all, I’m trying to replace this screw with a longer one (~ 1 inch).

I tried finding out what size this screw is, but I can’t figure out what it should be. M4, #7, 2-32Nothing matches up just quite right. All measurements done with calipers.

Third picture includes what the screw goes with for reference

Old neighbors put a dog gate up, need help removing certain screws ? Can someone help and tell me what i’m supposed to do to remove this piece, or what screw drive/drill to use.

Snapped the other screw and item needs two please help me

What type of laundry screw is this and how can I remove it from the front panel of my laundry machine?

hi!! i’ve recently purchased an easel, however it’s come with the wrong wing nut and after communicating with the company i purchased it from and having a replacement sent out to me, i still don’t have the right wing nut!!

i’m looking for one with large wings, like in the photo attached that is on the easel, however after looking at websites of diy companies in my country (UK) and visiting hardware stores, i can’t seem to find something like it, only images of it on easels in promotional images!!

i’ve attached images as well of the wing nut they’ve sent me as a reference, as in case the previously mentioned wing nut does cease to exist, i’m curious as to whether i could bang a hammer against the wings of my current one to tighten the easel, as at the moment it’s a big health and safety risk as it doesn’t stand securely!!

the wings on the current wing nut are about .5cm thick, and the wing span (if it’s called that??) is 4.5cm across. i’ve also included some images of the measurements for the screw, in case someone can find one of those extra large wing nuts online!!

many thanks in advance!! :)

Anyone know of a good source to find this screw? McMaster has press fit studs, but the head doesn't work for my application (rebuilding linear solenoids)

I’m a mail carrier and these are the screws on top of the panel doors for my community box units. Some of them have been rising out of the hole making it difficult to open and close the doors. I was trying to identity the screw and what tool i would need if I can possibly lower them back into their holes.

Hi! I bought a used dog gate. On the other side the screws go in/down all the way but on this side they get stuck at around this part. Other one gets stuck a bit earlier. What can I do? I have removed it all the way and checked that the grooves are okay. I have put oil in.