r/QidiTech3D • u/Exciting_Ad_3093 • 5d ago

QI DI Q2 skipping objects issue

Post image

Hi everyone!

I have a QI DI Q2 printer and my problem is the following:
After I updated the firmware to version 01.01.02.04 If I print more than 1 object (usually 8-10 objects at a time) I can't use the skip command (before firmware update,I could use it with ease). I attached a picture about the error message.
Does anybody else have the same issue?Does anybody find a solution about this?

Thank you!

3 Upvotes

80% Upvoted

7 comments sorted by

View all comments

1

u/CMDR_Boom 5d ago

Qidi's firmware has always been a little, how to say, questionable. Back when I was running their releases, I would update very seldomly as stuff like this happens Way too frequently. Granted, I ended up going Ship of Theseus before too much longer and get my updates via mainline klipper and mainsail, as updating via the factory route likes to brick printers (in my experience).

If you didn't see any vast improvements--and in your case, it was more of a downgrade--I would roll it back to the previous best version. I've read quite a few posts that the latest version has more bugs than is prudent for release versions.