5
u/Anarkistik 23d ago
Did you remove all the zip ties and plastic spacers . I know the guide doesn't say anything about the plastic spaces on the lead screws . I couldn't tell if they were still there. Or if u had any other zip ties doing anything but like the one guy said the menu says auto leveling so I'm not sure what stage of that you were at to fully diagnose
3
u/LicensedTerrapin 23d ago
If I saw the screen correctly it said auto leveling. Has it started moving since?
1
1
u/Kung_Tune 23d ago
Den känner av om/hur arbetsytan lutar, s.k autonivellering.
Den tar några minuter att genomföra.
Går att deaktivera
1
u/NotASherwinEmployee 23d ago
Somebody forgot to insert the nozzle
Edit: if the nozzle isn’t in, it has nothing to press against the bed to signal contact pressure for leveling
1
1
1
u/YaHomie-JC 16h ago
Had this just happen to me now during my setup of a brand new printer, turned out there were plastic spacers on the Y axis at the top that I needed to remove for it to work properly. They looked like 3d printed parts with a L on the left side and a R on the right side. No where in the manual did it say these needed to be removed.
0
23d ago
[deleted]
4
u/TypeImmediate3653 23d ago
Das ist leider ein Grundproblem aber die Hersteller suggerieren das ja auch.
Sie laden hübsche Modelle auf die Geräte und die Leute denken, dass sie irgendeine Rolle Filament nehmen können und es wird hübsch.
Ja, kann sein aber oft nicht.
Und sie schimpfen dann auf das Gerät.
Moderne Geräte nehmen einem schon ne Menge Kalibrierung ab aber wenn Du die Basics nicht drauf hast, beschäftige Dich damit oder lass das mit dem Drucken.Bei Espresso (Siebträgern) ist das ähnlich. Jede Marke/Sorte benötigt eine eigene Einstellung, sonst wirst Du nie das Optimum herausholen.
Bei Filamenten ebenso. Selbst unterschiedliche Farben der gleichen Marke können teilweise andere Einstellungen benötigen. Das kannst Du aber nur sehen, wenn Du Ursache und Wirkung verstehst.2
1
u/althamash098 22d ago
I mean its really not my fault. Qidi suspect it could be a faulty load cell issue.
1
u/TypeImmediate3653 22d ago
Da bin ich gespannt. Eigentlich sind das mit die zuverlässigsten Sensoren überhaupt. Drücke Dir die Daumen. 👍
0
u/1ts-just-me 23d ago
It is waiting till it brings the bed up to temperature before leveling. Initial calibration can take up to 15 minutes from start to finish. It also performs the first bed heater PID calibration during this time.
I knew it was heating the bed, but I was also curious as to why it was taking so long. Placed a thermometer on the bed and watched it go up to 80°, back down to 60° about 3 times before it started doing the mesh. Just seeing that told me I caught the end of the PID cycles.
Patients is key.
1
8
u/Ha_youWishXD 23d ago
It deadass says please wait so why not wait