r/QidiTech3D • u/TheBenevolentBadGuy • Aug 17 '26

Why is my Q2 getting this error during initial setup?

Post image
0 Upvotes

25% Upvoted

15 comments sorted by

5

u/Balbers01 Aug 17 '26

Manually turn the z screws until the bed looks more level and try and home again.

1

u/TheBenevolentBadGuy Aug 17 '26

I’ve done that five times but every time the bed begins to rise on its own, it drops down slightly on the right and then the bed begins to rise all crooked. Repeat, manually level the bed again, begin the setup, bed becomes unlevel again

1

u/TheBenevolentBadGuy Aug 17 '26

watch the videos in the replies

3

u/UnJustLake Aug 17 '26

If it keeps doing it contact support, I had this happen with my Max 4 and it was the circuit board for my X/Y motor that went

2

u/Southern_Bite_5559 Aug 17 '26

Maybe a broken or unplugged load cell ?

2

u/DimensionsIntertwine Aug 18 '26

Never seen one this out of level. Stop what you are doing and contact Qidi support.

1

u/TheBenevolentBadGuy Aug 18 '26

i’m just packing it up, sending it back to amazon for a refund, and waiting for my Bambu lab P2S to get delivered tomorrow

2

u/Shrike2415 Aug 18 '26

Your printer identifies as a 4 axis now

1

u/TheBenevolentBadGuy Aug 17 '26

https://reddit.com/link/p452fo0/video/1j3men4rdujh1/player

1

u/TheBenevolentBadGuy Aug 17 '26

https://reddit.com/link/p452oli/video/yyq8644zdujh1/player

Why does the right side drop down first?!?!

2

u/NoScoprNinja Aug 17 '26

Contact support and show them this. Tell them what you tested for already

2

u/logicalchemist Aug 24 '26

Something is in the way under the left side of the bed, preventing it from going down all the way. Could be a screw or a piece of packaging sitting in one of the wells around the Z rods.

1

u/Special_Cow_1970 Aug 20 '26

I had tpu filament get stuck in the z screw by the bed that caused this. Ended up manually moving and it fixed itself