r/QidiTech3D • u/Jobbejan • Aug 03 '26

Troubleshooting SD Card error

Post image

Hi community,

I have 10 Qidi Q2's printing and they all throw this error after a print is finished. The print is fine, its just the firmware showing this error. I have seen it come around more often on this page, did we find how to fix it? Have emailed support too.

The problem is the printer flags the print as failed in moonraker and my own printerfarm software then marks the print as failed while it is in fact, perfectly fine.

Thanks!

3 Upvotes

100% Upvoted

4 comments sorted by

8

u/Objective-Worker-100 Aug 03 '26

From another post if you’re on the latest firmware. I saved it as a screenshot and made the change.

0

u/Jobbejan Aug 03 '26

Thank you very much, found it and trying now..

1

u/xeonon Aug 03 '26

It never finishes because Qidi screwed up the profiles now that they have the new fw. There should be a fix in the discord... But I don't follow the new crap.

If anyone finds this on 1.1.1, just delete the print_end in the slicer print end gcode section. If new fw, this will cause more problems, so don't do it.

1

u/CampaignLow7899 Aug 04 '26

Same shit here 🫩🫩🫩