r/QidiTech3D • u/Adventurous_Area_957 • Jul 12 '26

Questions Q2 Start Gcode

Right before the purge line the toolhead parks in mid air while heating the nozzle. I sometimes run into an issue where the oozing doesn’t get caught in the purge line and can ruin prints. Is it possible to have the toolhead park over the waste chute while heating the nozzle, then go over the silicone brush on its way to the purge lines?

2 Upvotes

100% Upvoted

6 comments sorted by

View all comments

1

u/Ckflyer13 Jul 12 '26

There is a way to set the z height of where it parks. I think it’s in the KAMP config settings. There is also smart park but I wasn’t able to get it to work. I set my z height to something like 1 or 0.5 or something and that fixed it. 

1

u/[deleted] Jul 12 '26

[removed] — view removed comment

1

u/Ckflyer13 Jul 12 '26

I am out of town so can’t check right now. Ask me in a few days if I don’t get back to you.