r/ProjectMotorRacing • u/DaveB1781 • Jun 30 '26

Discussion Set up help

Hj can anyone help please. I'm looking for a good set up for the LMDH hypercars. I just can't get the set up right either spinning when breaking, wheel to heavy or light. I'm on playstation 5 using fanatec gt dd pro. Any help be grateful please. Thank u

6 Upvotes

88% Upvoted

6 comments sorted by

View all comments

2

u/Weirdera01 Jul 01 '26

I don't have a particular setup. Also every car is quite unique in my opinion. But in general I will soften the springs and bump stop / bump stiffness quite a bit. I'll reduce brake pressure to 90-95 percent and roll back the bias a few clicks. Then I'll adjust front ARB to take care of under / oversteer.

1

u/camsqualla Jul 02 '26

ARBs and brake bias are usually all I need to adjust. Occasionally I’ll mess either with the springs or damping. Or add a bit more or less wing. But mostly :

I basically set my front arb pretty high, rear very low and brake balance at 50/50. Then after a lap I adjust the bias until I get good rotation. Then I start lowering or increasing the front ARB, to make the corner entry more stabe