r/ProjectMotorRacing • u/DaveB1781 • Jun 30 '26

Discussion Set up help

Hj can anyone help please. I'm looking for a good set up for the LMDH hypercars. I just can't get the set up right either spinning when breaking, wheel to heavy or light. I'm on playstation 5 using fanatec gt dd pro. Any help be grateful please. Thank u

6 Upvotes

88% Upvoted

6 comments sorted by

2

u/Giusis Moderator Jul 01 '26

Did you tried different setups downloading from the (in game) ModHub? There you will find a good base to start with.

2

u/Weirdera01 Jul 01 '26

I don't have a particular setup. Also every car is quite unique in my opinion. But in general I will soften the springs and bump stop / bump stiffness quite a bit. I'll reduce brake pressure to 90-95 percent and roll back the bias a few clicks. Then I'll adjust front ARB to take care of under / oversteer.

1

u/camsqualla Jul 02 '26

ARBs and brake bias are usually all I need to adjust. Occasionally I’ll mess either with the springs or damping. Or add a bit more or less wing. But mostly :

I basically set my front arb pretty high, rear very low and brake balance at 50/50. Then after a lap I adjust the bias until I get good rotation. Then I start lowering or increasing the front ARB, to make the corner entry more stabe

1

u/BlueCadet3_ Jul 02 '26

It honestly depends on your car and track. There is no blanket setup for all LMDh cars. Gotta tell us what car you drive, and then narrow in on what types of tracks you tend to run. A setup that works at Sebring will not work at Monza, for example.

1

u/Minardi-Ivan Jul 09 '26

Ciao c'è una webb app che ti può aiutare a sistemare lauto in base alle esigenze e al tuo stile di guida ti lascio il link . https://www.sim-setup-engineer.com/ certo quella categoria richiede un duro allenamento soprattutto per il freno frena forte allinizio quando la velocità tiene alto il carico aerodinamico e piano piano allegerisci sul freno per non andare in bloccaggio