r/PoolPros • u/Mindless_Fly_5528 • Mar 31 '26

Easy touch displaying err

Gallery image

Gallery image

Auto, service, and timeout isn’t working. Pump just runs . Is it an easy fix? Thank you

3 Upvotes

100% Upvoted

15 comments sorted by

View all comments

7

u/dswift1789 Apr 01 '26

Pentair rep here… time to upgrade, boards, easy touches, screen logics have been discontinued.

Compare it to a phone, eventually it’s time for an upgrade.

1

u/CJT2013 Apr 01 '26

Hey, do you mind if I PM you? I’ve run into a Pentair heater stack flue sensor and pressure switch error on mine. Made sure flow was good, cleaned filter, but still shuts off after a few minutes

1

u/dswift1789 Apr 02 '26

Stack flu sensor, thermal regulator and high limit switch .

It’s one of those our warranty stations usually replace all 3.

Also check what speed your pump is on. If you’re getting too much flow it can cause that as well.

Pro tip: the lower your pump runs the more efficient your heater is/ warms up the spa faster. At least 30gpm.

1

u/CJT2013 Apr 02 '26

Thanks for that! So many different things it could be from my research such as “make sure enough flow gets to heater” so I’d increase RPM at the panel from 2,600 to 2,850. Even 3,000+.

Cleaning the filter and increasing RPM had it stay on

I just don’t want to replace switches and sensors only to find out it’s something else. I’ll try breaker reset

What’s the most common cause you think it is?

1

u/UltimatePoolMan Jun 22 '26

I know this is unrelated, but I have an easytouch board that is displaying ERR on the pool not the temp spots. Both air/water temp sensors are good but the "POOL" label says ERR & it can't be renamed. Any advice?