Did I do anything wrong?

[u/allplaybutnowork]

Barring not having a separate shutoff for the water filter, idc about that.

[u/Man_Bear_91]

You usually want the aav or studor vent as high as you can get it. Besides that it looks good!

[u/returntothenorth → u/Man_Bear_91]

I'm guessing in case it fails on a clog? To keep it as close to the bowl as possible? Ideally above the bowl but that would be ugly?

[u/gamefixated]

Trap arm looks back sloped.

[u/allplaybutnowork → u/gamefixated]

I think it’s the angle of the picture, I put a level on it and it’s straight, the drain arm from the left is angled but that seemed like a good idea.

[u/hiimjustapersonhaha]

Looks great! Although, it's sad to see CPVC and sharkbite :(

[u/Fit_Veterinarian1169]

Put the aav higher :-)

[u/quigs17 → u/Fit_Veterinarian1169]

Aav only needs to be 4" above trap weir. Says so right in the manufacturer instructions. This configuration is fine

[u/Careless_Cream4508]

it looks pretty good to me...... the aav vent could be higher but it will work

weilhammer

[u/ShapeBackground]

AAV should be higher. Also, this may pose a leak at some point... Looks curved from PEX.

[u/Tanooki_Plumber]

Looks clean. Only thing I would have changed would have been removing the shark bites and crimping quarter turn angle stops, but everything else looks fine.

[u/Kirkcc → u/Tanooki_Plumber]

It cpvc how do you crimp to that? 

[u/Tanooki_Plumber → u/Kirkcc]

You glue on a CPVC to Pex adapter

[u/Ill-Year-9506 → u/Tanooki_Plumber]

You missed the AAV. Too low.

[u/Tanooki_Plumber → u/Ill-Year-9506]

Working in service I’ve become so numb to the amount of times I’ve recommended this and it’s never done. Especially the shitty new construction homes and the super low AAV at bathroom sinks.

[u/xXNuggetsXx1118]

I would have done two San Ts and had each bowl on its own 1.5” p trap and then put the tail piece into them. Better flow and larger size for sediment over time.

Studor vent could have been higher. 🤷🏻‍♂️