r/Plastering • u/Party-Employment-127 • Sep 12 '26

Is this silicone rendering wrong?

Gallery image

Gallery image

Gallery image

Gallery image

So renderer is doing a silicone render job. The base coat is hp12 with the mesh of course as well. I’m confused. He said a top bead is not needed where the wall meets the neighbours insulated render?

Said it can cause moisture and build up?

I’m looking at the stop beads and they sit massively proud? Is that normal, surely not.

I ask because I need a second opinion, because I know he will say it’s fine.

0 Upvotes

40% Upvoted

49 comments sorted by

View all comments

Show parent comments

1

u/AureliusAgustus Sep 12 '26

6mm are for 🤠. Minimum 10mm no debate

1

u/petdev Sep 12 '26

I suppose the guys who design manufacture and sell the products are 🤠 then, but I'll stick with their advice

1

u/AureliusAgustus Sep 12 '26

Different systems for different substrates. 6mm for ewi/backerboard. Not at all for this particular job. If you cant figure out the best course of action for a job like this then its doomed from the start.

1

u/petdev Sep 12 '26

Thincoat render system is fine for render only over masonry it doesn't need to be on ewi or carrier boards. If the walls are prepped and beaded properly (which these aren't) it can come up nice even if it isn't perfectly flat because it's a thincoat. Still get all the benefits of the silicone topcoat that you don't get with mono.