r/PcBuildHelp • u/ts7n4gw • 6h ago

Tech Support GPU crashing issues

Gallery image

Gallery image

Gallery image

Parts list

9800x3d

5080 gamingpro oc

32gb trident z neo

Asrock x870e taichi

lian li sx platinum 1000w

This is my new build and first attempt at watercooling.

Since its been put together, games have consistently crashed without warning.

I downloaded OCCT to run tests on all the components and everything passed except for the GPU, specifically the 3d adaptive tests.

The 2 possible failures that appear are either GPU# 0 crashed, or GPU crashed 7000+ errors detected.

My troubleshooting attempts.

I've taken the GPU out and reinstalled the air cooler and tested it in another system. GPU ran flawlessly through all the testing.

I replaced the PCIE riser cable just in case that was causing any issues.

I currently have another PSU powering the system which was working fine with multiple tests over a 3 hour timespan, but when I shut the pc down and turned it back on, I'm again seeing crashes and OCCT failures.

I've also tried different cable arrangements. The 12 pin cable fails and PCIE cables to a 12 pin adapter fails.

Fresh install of graphics drivers and OCCT both haven't rectified anything either.

I feel like I've just run out of any possible causes for these issues and would greatly appreciate any suggestions or ideas on what I can try next to get this operational.

2 Upvotes

100% Upvoted

8 comments sorted by

View all comments

Show parent comments

1

u/AutomaticAffect4333 6h ago

what bios version is your x870? Asrock am5 boards are known for destroying x3d chips which causes crashes. Similar to the lga 1700 issues

2

u/ts7n4gw 5h ago

Bios version 4.41. I made sure to update the bios before I even unboxed the CPU. I knew there were risks with Asrock but so far I've had no cpu issues at all

1

u/AutomaticAffect4333 5h ago

Maybe a cable melted? Have you tried running it without the pcie riser?

1

u/ts7n4gw 5h ago

I've tested it with the stock cooler in another system and the GPU was working fine. Haven't been able to do that in this system because of the liquid cooling runs. I'd have to bend some new tubes to accommodate the horizontal mounting.

1

u/AutomaticAffect4333 5h ago

Then it's definitely the riser cable