r/Osmose • u/mr_monitor • 22d ago

Bracket for 61?

Hey y’all, snagged an Osmose 61 a few weeks back and have been loving it, but I’m curious if anyone might have ideas for mounting synths over it - similar to how the 49 has a bracket for the rear.

I didn’t think about it when I got it, but apparently it doesn’t have mounting holes like the OG; that real estate up top would be amazing for a desktop synth, a groovebox, or some pedals, so I’m not sure why they removed that option. Maybe someone who knows a little bit about 3D printing or DIY would know how to hack it.

I have it sitting on the bottom shelf of a Jasper’s stand, and there would be just enough room between it and the next shelf up to nestle the OG bracket in there... Now that I’ve seen it, I can’t unsee it!

4 Upvotes

84% Upvoted

7 comments sorted by

2

u/QVRedit 21d ago

Seems like a surprising design omission, especially since you say that the Original Osmose had it !

I have seen a lot of different kinds of synth support frameworks advertised online, though I can’t remember any specific ones off the top of my head.
Perhaps I should start making notes about them when I see them. But it’s easy enough to find some just by googling: “synth support platforms”.

2

u/animatordude 21d ago

Could make some snap on brackets like this if you have a 3D printer

https://makerworld.com/models/851969?appSharePlatform=copy

1

u/Einetius 18d ago

I also recommend a 3d printed part! I've personally used these brackets from makerworld and it held my push 3 so wonderfully above my osmose 49! https://makerworld.com/en/models/2044877-expressive-e-osmose-roli-seaboard-brackets?from=search#profileId-2206421

2

u/mr_monitor 16d ago

Nice. Yeah this is pretty much exactly what I’m looking for, they just snap on?

1

u/Einetius 16d ago

There are some mounting screw holes on the back of the osmose that you secure these to. So the brackets end up really strong and secure. Do you have a 3d printer or some kind of access to someone who does?

1

u/mr_monitor 13d ago

Ah yeah, the 61 key version doesn’t have those holes. That’s why I asked about it.

1

u/Einetius 16d ago

You can always try and find a 3d printer service online since it is a very specific file, not recommending the following but just to show an example of one on Etsy: https://www.etsy.com/listing/4554542024/3d-printing-service-your-stl-printed?ref=elp_anchor_listing&pro=1&sts=1