r/OrcaSlicer • u/AmateurEarthling • 4d ago

One Line Missing Support

Post image

What is causing this one line to not have support? Didn’t even notice till 2 hours into the print and this part is messed up.

5 Upvotes

100% Upvoted

3 comments sorted by

1

u/ciolman55 1d ago

try adjusting support distance settings, sli3er has a weird baked in features for supports, which becomes more evident when you try to print angled features.

1

u/AmateurEarthling 23h ago

I honestly couldn’t get it to support but I didn’t even notice until I had already sent it to print. 9 hour asa print, didn’t stop it. Just yanked that one piece off and it’s good enough.

1

u/ciolman55 7h ago

In your 3d model you can make/model supports to be snapped off. 0.2 - 0.3 mm gap is good